Experimental Analysis of Aerodynamic Characteristics of NACA 0012 Wing Model with Multiple Winglets

Md. Zadid Iqbal; Abdullah Al-Faruk; Md. Ashraful Islam

doi:10.38032/jea.2025.01.004

Authors

Md. Zadid Iqbal Department of Mechanical Engineering, Khulna University of Engineering & Technology, Khulna, Bangladesh
Abdullah Al-Faruk Department of Mechanical Engineering, Khulna University of Engineering & Technology, Khulna, Bangladesh https://orcid.org/0000-0002-5453-197X
Md. Ashraful Islam Department of Mechanical Engineering, Khulna University of Engineering & Technology, Khulna, Bangladesh

DOI:

https://doi.org/10.38032/jea.2025.01.004

Keywords:

NACA 0012, Winglets, Lift-induced Drag, Aerodynamic Characteristics, Wind Tunnel Experiment

Abstract

Downwash in the wing causes a reduction of lift and generates an additional drag, known as the lift-induced drag or the vortex drag for the finite wing. This induced drag ultimately deteriorates the aerodynamic performance of the aircraft. The technical potentiality of multi-winglets is examined in this work to reduce the induced drag without enlarging the wing’s span. Aerodynamic characteristics of the NACA 0012 airfoil section-built wing model with gradual increase of winglets have been studied using a subsonic wind tunnel of 1 m × 1 m × 1 m rectangular test section. An untwisted wing model tapered towered tip was constructed using the NACA 0012 airfoil sections for the wind tunnel experiments. Airfoil-shaped wooden plates of the same airfoil profile were used to make the winglets. Experiments were carried out on the wing with the winglets at 0°, 5°, 10° and 15° incidence angles. The results show that the wing with a gradual increase from one winglet to three winglets can reduce the induced drag and improve the aerodynamic performance. The lift coefficient increases up to 21.2%, and the drag coefficient decreases up to 27.2% when multiple winglets are attached with wing mode compared to single winglet. Enhancing lift performance, reducing vortex drag, and improving overall aerodynamic efficiency in multi-winglet configuration can improve fuel efficiency, leading to better aircraft performance.

References

Khan, M.M.I. and Al-Faruk, A., 2018. Comparative analysis of aerodynamic characteristics of rectangular and curved leading edge wing planforms. American Journal of Engineering Research (AJER), 7(5), pp.281-291. Available at: .

Anderson, J.D. Jr., 2011. Fundamentals of aerodynamics. 5th ed. New York: McGraw-Hill.

Houghton, E.L., Carpenter, P.W., Collicott, S.H. and Valentine, D.T., 2017. Aerodynamics for engineering students. 7th ed. Oxford: Butterworth-Heinemann.

Coimbra, R.F.F. and Catalano, F.M., 1999. Estudo experimental sobre pontas de asa para uma aeronave agrícola. Revista Brasileira de Engenharia Agrícola e Ambiental, 3(1), pp.99-105.

Krishnan, S.G., Ishak, M.H., Nasirudin, M.A. and Ismail, F., 2020. Investigation of aerodynamic characteristics of a wing model with RGV winglet. Journal of Aerospace Technology and Management, 12, e2020.

Smith, M., Komerath, N., Ames, R., Wong, O. and Pearson, J., 2001. Performance analysis of a wing with multiple winglets. 19th AIAA Applied Aerodynamics Conference. Reston, Virginia: American Institute of Aeronautics and Astronautics. doi:10.2514/6.2001-2407.

Kroo, I., McMasters, J. and Smith, S.C., 1996. Highly nonplanar lifting systems. Transportation Beyond 2000: Technologies Needed for Engineering Design.

Yates, J.E. and Donaldson, C.D., 1986. A fundamental study of drag and an assessment of conventional drag-due-to-lift reduction devices, NASA Technical Report, NASA-CR-180891.

Ismail, N., Usman, K.M., Balogun, M.B., Abdullahi, M., Faru, F.T. and Ibrahim, I., 2020. Effect of angle of attack on lift, drag, pitching moment and pressure distribution of NACA 4415 wing. Journal of Science Technology and Education, 8(1), pp.31-44.

Al-Atabi, M., 2006. Aerodynamics of wing tip sails. Journal of Engineering Science and Technology, 1(1), pp.89-98.

Eftekhari, S. and Al-Obaidi, A.S.M., 2019. Investigation of a NACA0012 finite wing aerodynamics at low Reynold’s numbers and 0o to 90o angle of attack. Journal of Aerospace Technology and Management, 11, e1519.

Cerón-Muñoz, H.D. and Catalano, F.M., 2006. Experimental analysis of the aerodynamic characteristics adaptive of multi-winglets. Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 220(3), pp.209-215.

Inam, M.I., Mashud, M., Al-Nahian, A. and Selim, S.M.S., 2010. Induced drag reduction for modern aircraft without increasing the span of the wing by using winglet. International Journal of Mechanical & Mechatronics Engineering IJMME-IJENS, 10(3), pp.49-53.

Sayem, M.S.H., Sagar, M.M., Alam, R. and Al-Faruk, A., 2024. Numerical analysis of aerodynamic characteristics of aeroplane wing with winglets. International Research Journal of Engineering and Technology, 11(5), pp.1601-1622.

Sayem, M.S.H. and Al-Faruk, A., 2020. Effect of cant angles on the aerodynamic performances of an airplane wing with blended type winglet: Numerical analysis. International Conference on Mechanical, Industrial and Energy Engineering. Khulna.

Yusoff, H. et al., 2022. The evolution of induced drag of multi-winglets for aerodynamic performance of NACA23015. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 93(2), pp.100-110. doi:10.37934/arfmts.93.2.100110.

Reddy, S.R., Sobieczky, H., Dulikravic, G.S. and Abdoli, A., 2016. Multi-element winglets: Multi-objective optimization of aerodynamic shapes. Journal of Aircraft, 53(4), pp.992-1000. doi:10.2514/1.C033334.

Padmanathan, P. et al., 2024. Parametric optimization study of novel winglets for transonic aircraft wings. Applied Sciences, 14(17), p.7483. doi:10.3390/app14177483.

Sethunathan, P., Ramasamy, K.K., Sivasubramaniyam, A.P. and Kannan, R., 2024. Aerodynamic performance of semi-wing with multiple winglets operating at low- and medium-range Reynolds numbers. International Journal of Modern Physics C, 35(10), p. 2450134.

Bala, M.N.V.S.S., Kalali, S.K.G., Goud, B.N., Kumar, A.S. and Gupta, M.S., 2023. Flow investigation of a multiple winglet wing model. AIP Conference Proceedings, 2492 (1), p.020002.

El Haddad, N., 2015. Aerodynamic and structural design of a winglet for enhanced performance of a business jet. Master’s Thesis, Embry-Riddle Aeronautical University.

Lovegren, J. and Hansman, R.J., 2011. Estimation of potential aircraft fuel burn reduction in cruise via speed and altitude optimization strategies, Master's Thesis, Massachusetts Institute of Technology.

Ulrich, L., Roche, L. and Consulting, L.R., 2001. Induced drag reduction with the WINGGRID device. Aerodynamic Drag Reduction Technologies. Berlin, Heidelberg: Springer Berlin Heidelberg, pp.304-311. doi:10.1007/978-3-540-45359-8_32.

Ebrahimi, A. and Mardani, R., 2018. Tip-vortex noise reduction of a wind turbine using a winglet. Journal of Energy Engineering, 144(1), p. 04017052.

Yin, K., 2017. A study of carbon dioxide emissions reduction opportunities for airlines on Australian international routes. Master’s Thesis, The University of Queensland, Brisbane.

Arifuzzaman, M. and Mashud, M., 2012. Design construction and performance test of a low-cost subsonic wind tunnel. IOSR Journal of Engineering (IOSRJEN), 2(10), pp.83-92.

Rahman, M.M., Shayor, A.A., Al-Faruk, A. and Evan, M.T.R., 2025. Numerical investigation with experimental validation of aerodynamics performance of NACA 2414 airfoil with passive momentum injection through channeling. Results in Engineering, 25, p.104533.

Berens, M., 2008. Potential of multi-winglet systems to improve aircraft performance, Master’s Thesis, Technical University Berlin, Berlin.